Page 1 of 1

Default validation mode setting not used

Posted: Thu Aug 10, 2017 5:28 am
by Frontier
H there :)

When I start the latest CSE HTML Validator (17.04) and start to use the internal browser, and the default setting is set to "full", I still get a "errors only" comment + I have to switch the validation mode to full before being able to see the warnings etc.

Looking in the "Validate" menu, I can see that it's set to "Use default validation mode". And "Options - Validator engine options - Default validation mode" is set to "Full".

Re: Default validation mode setting not used

Posted: Thu Aug 10, 2017 7:59 am
by Albert Wiersch
Hello,

I'm sorry for the trouble.

Do you have flag 58 unchecked? This could be the problem. To check this, check the 'Validator Engine->Flags' options page in the Validator Engine Options. If flag 58 is unchecked, it will override the default validation mode in favor of an 'Errors only' check.

Re: Default validation mode setting not used

Posted: Thu Aug 10, 2017 9:40 am
by Frontier
It was disabled...now enabled, and I don't get the error anymore AND it works as intended - thank you :)

Re: Default validation mode setting not used

Posted: Thu Aug 10, 2017 10:42 am
by Albert Wiersch
Great! I'm glad that fixed it and you're very welcome. :D